Burkert Type 8681 Manual do Utilizador descarregar pdf (Página 83)

Replacement of Components and Modules

Installation procedure:

Carefully insert the entire electronics module into the recess in the lower housing part.

→

Plug the electronics module carefully onto the contact pins for the position measuring system. →

Refasten the electronics module with the Torx T10 screw (torque 0.4 Nm). →

Reattach the electrical connections. →

Check DIP switch positions (4-switch block for color coding, 8-switch block on DeviceNet electronics module →

for address and Baud rate) and set the previously noted switch settings, if necessary.

If necessary, set AS interface address and jumper positions.

→

Perform Teach-In process (see chapter → 15.1. Setting the Position Measuring System (Teach-In)).

Be sure to work carefully and cautiously, so that the electronics are not damaged.

Close the housing observing the notes contained in chapter "

→ 8. Opening and Closing the Housing".

Changing the Valves19.3.

According to the design, zero to three valve modules have been installed in the control head. The valves have

been designed with the ﬂow restriction equipment for intake and exhaust air and must be installed as a valve

module.

Valve module from above

Flow restriction

screws

Torx screws (T10),

tightening torque:

1 Nm

Note:

Disassemble/assemble the valves in upright position as there is

otherwise a risk that the non-return valve falls out!

Valve moduleFig. 32:

Procedure:

Open the housing observing the notes contained in chapter "

→ 8. Opening and Closing the Housing".

If necessary, mark the electrical connections to ensure correct assignment during reinstallation.

→

english

Control Head Type 8681

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 89 90

Sem comentários

Burkert Type 8681 Manual do Utilizador Página 83